Whois & Analysis for hunterindustries.com

Irrigation sprinklers are sprinklers providing irrigation to agriculture, crops, vegetation, or for recreation, as a cooling system, or for the control of airborne dust, landscaping and golf courses.

The sprinkler system irrigates the field and thus it is widely used in sandy areas as it checks the wastage of water through seepage and evaporation.

Sprinkler irrigation is a method of applying irrigation water which is similar to natural rainfall.

Water is distributed through a system of pipes usually by pumping.

It is then sprayed into the air through sprinklers so that it breaks up into small water drops which fall to the ground.

The pump supply system, sprinklers and operating conditions must be designed to enable a uniform application of water.

Hunter Industries is a manufacturer of irrigation equipment for the landscaping and golf course industries, based in San Marcos, California.

They are the second largest employer in San Marcos after the San Marcos Unified School District.

Drip irrigation is a form of irrigation that saves water and fertilizer by allowing water to drip slowly to the roots of many different plants, either onto the soil surface or directly onto the root zone, through a network of valves, pipes, tubing, and s.

It is done through narrow tubes that deliver water directly to the base of the plant.

It is chosen instead of surface irrigation for various reasons, often including concern about minimizing evaporation.

A valve is a device that regulates, directs or controls the flow of a fluid (gases, liquids, fluidized solids, or slurries) by opening, closing, or partially obstructing various passageways.

Valves are technically fittings, but are usually discussed as a separate category.

In an open valve, fluid flows in a direction from higher pressure to lower pressure.

The word is derived from the Latin valva, the moving part of a door, in turn from volvere, to turn, roll.

A nozzle is a device designed to control the direction or characteristics of a fluid flow (especially to increase velocity) as it exits (or enters) an enclosed chamber or pipe.